Date: Fri, 8 Dec 2000 02:15:59 -0500 (EST) From: Tim McMillen <timcm@umich.edu> To: Danny <dannyho@bigpond.net.au> Cc: freebsd-questions@FreeBSD.ORG Subject: Re: Sound Card How To? Message-ID: <Pine.SOL.4.10.10012080209250.21545-100000@qix.gpcc.itd.umich.edu> In-Reply-To: <00120817032502.00444@freebsd.freebsd.org>
next in thread | previous in thread | raw e-mail | index | archive | help
Actually there is a new section in the handbook for how to configure sound cards. See http://www.freebsd.org/handbook/sound.html I did the steps you listed there (except pcm not pcm0) with an ISA card (Not sure if it is PNP or not) and it worked fine. Tim On Fri, 8 Dec 2000, Danny wrote: > - Hello > - I haven't configured a sound card for FreeBSD fro a long time > > - Can someone type out if the steps are correct below : - > > 1) Add "device pcm0" to the Kernel file > 2) Compile Kernel > 3) cd /dev > 4) ./MAKEDEV snd0 > > > - Here is the output of dmesg for the maillign list : - > > Probing for PnP devices: > Copyright (c) 1992-1999 FreeBSD Inc. > Copyright (c) 1982, 1986, 1989, 1991, 1993 > The Regents of the University of California. All rights reserved. > FreeBSD 3.3-RELEASE #0: Thu Sep 16 23:40:35 GMT 1999 > jkh@highwing.cdrom.com:/usr/src/sys/compile/GENERIC > Timecounter "i8254" frequency 1193182 Hz > CPU: Pentium/P54C (166.59-MHz 586-class CPU) > Origin = "GenuineIntel" Id = 0x52c Stepping = 12 > Features=0x1bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8> > real memory = 67108864 (65536K bytes) > avail memory = 61632512 (60188K bytes) > Preloaded elf kernel "kernel" at 0xc0379000. > Probing for devices on PCI bus 0: > chip0: <Intel 82437VX PCI cache memory controller> rev 0x02 on pci0.0.0 > chip1: <Intel 82371SB PCI to ISA bridge> rev 0x01 on pci0.7.0 > ide_pci0: <Intel PIIX3 Bus-master IDE controller> rev 0x00 on pci0.7.1 > vga0: <S3 Trio graphics accelerator> rev 0x54 int a irq 255 on pci0.9.0 > ed1: <NE2000 PCI Ethernet (RealTek 8029)> rev 0x00 int a irq 10 on pci0.10.0 > ed1: address 00:60:67:2c:38:83, type NE2000 (16 bit) > CSN 1 Vendor ID: YMH0020 [0x2000a865] Serial 0xffffffff Comp ID: PNPb02f [0x2fb0d041] > Probing for devices on the ISA bus: > sc0 on isa > sc0: VGA color <16 virtual consoles, flags=0x0> > ed0 not found at 0x280 > fe0 not found at 0x300 > atkbdc0 at 0x60-0x6f on motherboard > atkbd0 irq 1 on isa > psm0 not found > sio0 at 0x3f8-0x3ff irq 4 flags 0x10 on isa > sio0: type 16550A > sio1 at 0x2f8-0x2ff irq 3 on isa > sio1: type 16550A > fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa > fd0: 1.44MB 3.5in > wdc0 at 0x1f0-0x1f7 irq 14 on isa > wdc0: unit 0 (wd0): <FUJITSU MPD3064AT> > wd0: 6187MB (12672450 sectors), 13410 cyls, 15 heads, 63 S/T, 512 B/S > wdc0: unit 1 (atapi): <CD-920E/12A>, removable, intr, dma, iordy > acd0: drive speed 2062KB/sec, 120KB cache > acd0: supported read types: CD-DA > acd0: Audio: play, 255 volume levels > acd0: Mechanism: ejectable tray > acd0: Medium: no/blank disc inside, unlocked > wdc1 not found at 0x170 > wt0 not found at 0x300 > mcd0 not found at 0x300 > matcdc0 not found at 0x230 > scd0 not found at 0x230 > ppc0 at 0x378 irq 7 flags 0x40 on isa > ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode > lpt0: <generic printer> on ppbus 0 > lpt0: Interrupt-driven port > ppi0: <generic parallel i/o> on ppbus 0 > plip0: <PLIP network interface> on ppbus 0 > ie0: unknown board_id: f000 > ie0 not found at 0x300 > ep0 not found at 0x300 > ex0 not found > le0 not found at 0x300 > lnc0 not found at 0x280 > cs0 not found at 0x300 > ze0 not found at 0x300 > zp0 not found at 0x300 > adv0 not found at 0x330 > bt0 not found at 0x134 > aha0 not found at 0x134 > vga0 at 0x3b0-0x3df maddr 0xa0000 msize 131072 on isa > npx0 on motherboard > npx0: INT 16 interface > Intel Pentium detected, installing workaround for F00F bug > changing root device to wd0s1a > pid 316 (ftp), uid 1000 on /: file system full > pid 316 (ftp), uid 1000 on /: file system full > pid 290 (kfm), uid 1000 on /: file system full > pid 290 (kfm), uid 1000 on /: file system full > pid 271 (kwm), uid 1000 on /: file system full > pid 453 (communicator-4.6), uid 1000: exited on signal 10 > cd9660: RockRidge Extension > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-questions" in the body of the message > To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.SOL.4.10.10012080209250.21545-100000>