Date: Tue, 10 Apr 2007 08:54:36 +0000 From: "Christian Walther" <cptsalek@gmail.com> To: "RYAN M. vAN GINNEKEN" <luck@computerking.ca> Cc: freebsd-questions@freebsd.org Subject: Re: uhub0: port 2, set config at addr 2 failed Message-ID: <14989d6e0704100154l392cae2ds470b31869081a644@mail.gmail.com> In-Reply-To: <661846.891176168880189.JavaMail.root@shoemasters.com> References: <661846.891176168880189.JavaMail.root@shoemasters.com>
next in thread | previous in thread | raw e-mail | index | archive | help
On 10/04/07, RYAN M. vAN GINNEKEN <luck@computerking.ca> wrote: > Hello friendly FreeBSDier's i am tring to make my machine work with a Motorola usb modem and get the below errors in my dmesg. I would be very grateful if someone could help me with this problem. > > FreeBSD new.computerking.ca 6.2-STABLE FreeBSD 6.2-STABLE #0 > > usb0: <VIA 83C572 USB controller> on uhci0 > usb0: USB revision 1.0 > uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > uhub0: 2 ports with 2 removable, self powered > uhci1: <VIA 83C572 USB controller> port 0xa800-0xa81f irq 10 at device 7.3 on pc > i0 > uhci1: [GIANT-LOCKED] > usb1: <VIA 83C572 USB controller> on uhci1 > usb1: USB revision 1.0 > uhub1: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > uhub1: 2 ports with 2 removable, self powered > > Later in the demesg i get this either when i plug the modem in or if i reboot with it plugged in. Funny cause it worked once and gave me cdce0 in my ifconfig so i added a line to my /etc/rc.conf like this > > ifconfig_cdce0="inet 68.146.204.153 netmask 255.255.252.0" > > to set a static ip then restarted and it now it just gives me the below error and no device in shows up in my ifconfig > > uhub0: port 2, set config at addr 2 failed > uhub0: device problem (SHORT_XFER), disabling port 2 > > > also i have these in my dmesg the look strange to me and thought that mabey they might be related. > What Hardware are you on, to be more specific: Are these onboard USB ports, or is this a PCI board? Last time I've seen these messages I had an USB PCI board installed. The chip itself was claimed to be supported, but it was a newer revision. I guess it got recognised properly, but due to some revision specific changes it couldn't be initialised. In my case everything USB 2 didn't work, but the board was usable with USB 1 devices. Well, it just makes no sense if you want to attach a disk to it.
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?14989d6e0704100154l392cae2ds470b31869081a644>