Skip site navigation (1)Skip section navigation (2)
Date:      Thu, 21 Sep 2000 00:29:43 +0200 (CEST)
From:      Charlie Root <root@oblomow.demon.nl>
To:        freebsd-stable@freebsd.org
Subject:   UDMA write errors on stable and release
Message-ID:  <200009202229.e8KMThw12433@oblomow.demon.nl>

next in thread | raw e-mail | index | archive | help

Hi,

I am not sure if this is the right forum to ask, but since it concerns
4.1 stable I might as well try.


Since switching to a new motherboard I get the following errors:

Sep 14 22:37:27 oblomow /kernel.GENERIC: ad0: UDMA ICRC WRITE ERROR blk# 2523344 retrying
Sep 14 22:37:27 oblomow /kernel.GENERIC: ad0: UDMA ICRC WRITE ERROR blk# 2535904 retrying

Not only with this installation ( 4.1 Release ) but also with 4.1 stable (see
attached messages file)

I changed from an Abit AX5 motherboard with a K6 to an Abit KT7 with a Duron 600
(Via chipset).
Eventually these errors disappear because the system decides to switch to 
PIO4 mode for disk access. I have gone through the mailing list archive and
found several more reports about this, but no solution there.

The cable used to attach these UDMA33/66 capable drives is new and not too
long and should be capable of handling these speeds. The disks that worked 
are 2 *  WDC AC34300L.  I also tried a new IBM GXP 30 GB with the same result.

Suggestions anyone?

Marc Albers

/var/log/messages:

Sep 16 13:00:00 oblomow newsyslog[515]: logfile turned over
Sep 16 13:00:46 oblomow login: ROOT LOGIN (root) ON ttyv2
Sep 16 13:04:34 oblomow syslogd: exiting on signal 15
Sep 16 13:05:48 oblomow /kernel: Copyright (c) 1992-2000 The FreeBSD Project.
Sep 16 13:05:48 oblomow /kernel: Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
Sep 16 13:05:48 oblomow /kernel: The Regents of the University of California. All rights reserved.
Sep 16 13:05:49 oblomow /kernel: FreeBSD 4.1-STABLE #1: Sat Sep 16 13:03:01 CEST 2000
Sep 16 13:05:49 oblomow /kernel: root@oblomow.demon.nl:/usr/src/sys/compile/oblomowd
Sep 16 13:05:49 oblomow /kernel: Timecounter "i8254"  frequency 1193182 Hz
Sep 16 13:05:49 oblomow /kernel: CPU: AMD Duron(tm) Processor (600.03-MHz 686-class CPU)
Sep 16 13:05:49 oblomow /kernel: Origin = "AuthenticAMD"  Id = 0x630  Stepping = 0
Sep 16 13:05:49 oblomow /kernel: Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR>
Sep 16 13:05:49 oblomow /kernel: AMD Features=0xc0440000<<b18>,AMIE,DSP,3DNow!>
Sep 16 13:05:49 oblomow /kernel: real memory  = 134152192 (131008K bytes)
Sep 16 13:05:49 oblomow /kernel: avail memory = 126984192 (124008K bytes)
Sep 16 13:05:49 oblomow /kernel: Preloaded elf kernel "kernel" at 0xc0398000.
Sep 16 13:05:49 oblomow /kernel: Pentium Pro MTRR support enabled
Sep 16 13:05:49 oblomow /kernel: md0: Malloc disk
Sep 16 13:05:49 oblomow /kernel: npx0: <math processor> on motherboard
Sep 16 13:05:49 oblomow /kernel: npx0: INT 16 interface
Sep 16 13:05:49 oblomow /kernel: pcib0: <Host to PCI bridge> on motherboard
Sep 16 13:05:49 oblomow /kernel: pci0: <PCI bus> on pcib0
Sep 16 13:05:49 oblomow /kernel: pcib2: <PCI to PCI bridge (vendor=1106 device=8305)> at device 1.0 on pci0
Sep 16 13:05:49 oblomow /kernel: pci1: <PCI bus> on pcib2
Sep 16 13:05:49 oblomow /kernel: pci1: <NVidia model 0110 graphics accelerator> at 0.0 irq 11
Sep 16 13:05:49 oblomow /kernel: isab0: <VIA 82C686 PCI-ISA bridge> at device 7.0 on pci0
Sep 16 13:05:49 oblomow /kernel: isa0: <ISA bus> on isab0
Sep 16 13:05:49 oblomow /kernel: atapci0: <VIA 82C686 ATA66 controller> port 0xd000-0xd00f at device 7.1 on pci0
Sep 16 13:05:49 oblomow /kernel: ata0: at 0x1f0 irq 14 on atapci0
Sep 16 13:05:49 oblomow /kernel: ata1: at 0x170 irq 15 on atapci0
Sep 16 13:05:49 oblomow /kernel: pcm0: <Creative EMU10K1> port 0xdc00-0xdc1f irq 5 at device 11.0 on pci0
Sep 16 13:05:49 oblomow /kernel: fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0xe400-0xe43f mem 0xdf000000-0xdf0fffff,0xdf100000-0xdf100fff irq 10 at device 13.0 on pci0
Sep 16 13:05:49 oblomow /kernel: fxp0: Ethernet address 00:02:b3:09:01:78
Sep 16 13:05:49 oblomow /kernel: ncr0: <ncr 53c810a fast10 scsi> port 0xe800-0xe8ff mem 0xdf101000-0xdf1010ff irq 11 at device 17.0 on pci0
Sep 16 13:05:49 oblomow /kernel: pcib1: <Host to PCI bridge> on motherboard
Sep 16 13:05:49 oblomow /kernel: pci2: <PCI bus> on pcib1
Sep 16 13:05:49 oblomow /kernel: fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
Sep 16 13:05:49 oblomow /kernel: fdc0: FIFO enabled, 8 bytes threshold
Sep 16 13:05:49 oblomow /kernel: fd0: <1440-KB 3.5" drive> on fdc0 drive 0
Sep 16 13:05:49 oblomow /kernel: atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
Sep 16 13:05:49 oblomow /kernel: atkbd0: <AT Keyboard> irq 1 on atkbdc0
Sep 16 13:05:49 oblomow /kernel: psm0: <PS/2 Mouse> irq 12 on atkbdc0
Sep 16 13:05:49 oblomow /kernel: psm0: model Generic PS/2 mouse, device ID 0
Sep 16 13:05:49 oblomow /kernel: vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Sep 16 13:05:49 oblomow /kernel: sc0: <System console> on isa0
Sep 16 13:05:49 oblomow /kernel: sc0: VGA <16 virtual consoles, flags=0x200>
Sep 16 13:05:49 oblomow /kernel: sio1: configured irq 3 not in bitmap of probed irqs 0
Sep 16 13:05:49 oblomow /kernel: ppc0: <Parallel port> at port 0x378-0x37f irq 5 on isa0
Sep 16 13:05:49 oblomow /kernel: ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode
Sep 16 13:05:49 oblomow /kernel: ppbus0: IEEE1284 device found /NIBBLE/ECP
Sep 16 13:05:49 oblomow /kernel: Probing for PnP devices on ppbus0:
Sep 16 13:05:49 oblomow /kernel: ppbus0: <HEWLETT-PACKARD DESKJET 815C> MLC,PCL,PML
Sep 16 13:05:49 oblomow /kernel: ppi0: <Parallel I/O> on ppbus0
Sep 16 13:05:49 oblomow /kernel: lpt0: <Printer> on ppbus0
Sep 16 13:05:49 oblomow /kernel: lpt0: Interrupt-driven port
Sep 16 13:05:49 oblomow /kernel: isic0 at port 0x1a40-0x1a5f,0x1620-0x163f,0x620-0x63f,0xe20-0xe3f,0x1240-0x125f,0x240-0x25f,0xa40-0xa5f irq 4 flags 0x4 on isa0
Sep 16 13:05:49 oblomow /kernel: isic0: AVM A1 or Fritz!Card Classic
Sep 16 13:05:49 oblomow /kernel: i4btel: 2 ISDN telephony interface device(s) attached
Sep 16 13:05:49 oblomow /kernel: i4brbch: 4 raw B channel access device(s) attached
Sep 16 13:05:49 oblomow /kernel: i4bipr: 4 IP over raw HDLC ISDN device(s) attached (VJ header compression)
Sep 16 13:05:49 oblomow /kernel: IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to deny, unlimited logging
Sep 16 13:05:49 oblomow /kernel: i4bctl: ISDN system control port attached
Sep 16 13:05:49 oblomow /kernel: i4btrc: 4 ISDN trace device(s) attached
Sep 16 13:05:49 oblomow /kernel: i4bisppp: 4 ISDN SyncPPP device(s) attached
Sep 16 13:05:49 oblomow /kernel: i4b: ISDN call control device attached
Sep 16 13:05:49 oblomow /kernel: ad0: 4104MB <WDC AC34300L> [8896/15/63] at ata0-master using UDMA33
Sep 16 13:05:49 oblomow /kernel: ad2: 4104MB <WDC AC34300L> [8896/15/63] at ata1-master using UDMA33
Sep 16 13:05:49 oblomow /kernel: acd0: CDROM <ATAPI CD-ROM DRIVE 24X MAXIMUM> at ata0-slave using PIO4
Sep 16 13:05:49 oblomow /kernel: Waiting 15 seconds for SCSI devices to settle
Sep 16 13:05:49 oblomow /kernel: Mounting root from ufs:/dev/ad0s3a
Sep 16 13:05:49 oblomow /kernel: cd0 at ncr0 bus 0 target 0 lun 0
Sep 16 13:05:49 oblomow /kernel: cd0: <TOSHIBA DVD-ROM SD-M1401 1007> Removable CD-ROM SCSI-2 device 
Sep 16 13:05:49 oblomow /kernel: cd0: 10.000MB/s transfers (10.000MHz, offset 8)
Sep 16 13:05:49 oblomow /kernel: cd0: Attempt to query device size failed: NOT READY, Medium not present
Sep 16 13:05:49 oblomow /kernel: cd1 at ncr0 bus 0 target 4 lun 0
Sep 16 13:05:49 oblomow /kernel: cd1: <PLEXTOR CD-R   PX-W8220T 1.02> Removable CD-ROM SCSI-2 device 
Sep 16 13:05:49 oblomow /kernel: cd1: 10.000MB/s transfers (10.000MHz, offset 8)
Sep 16 13:05:49 oblomow /kernel: cd1: Attempt to query device size failed: NOT READY, Medium not present - tray closed
Sep 16 13:05:49 oblomow /kernel: ad0: UDMA ICRC WRITE ERROR blk# 2523344 retrying
Sep 16 13:05:49 oblomow last message repeated 19 times


To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200009202229.e8KMThw12433>