Date: Sun, 27 Oct 2002 11:19:15 -0800 (PST) From: Matthew Dillon <dillon@apollo.backplane.com> To: David Nicholas Kayal <davek@saturn5.com> Cc: nbari@unixmexico.com, freebsd-hackers@FreeBSD.ORG Subject: Re: i am looking for a 5 volt signal Message-ID: <200210271919.g9RJJFEm091313@apollo.backplane.com> References: <Pine.BSF.4.44.0210270918380.364-100000@blackbox.yayproductions.com>
next in thread | previous in thread | raw e-mail | index | archive | help
: :Shouldn't the fact that the signal is in a while loop keep the 5 volt :signal going? Isn't the parallel port being blasted with the :value 255 over and over again? : :The serial port will not fulfill what i am ultimately trying to achive. I :am trying to have the parallel port to control 8 relays each turing :on/off based upon which bit i send out to the port. : :.. :> try using also the serial port and a logical buffer :> :> the 5 volt signal is very fast and your multimeter is maybe not to fast :> :> > I'm looking for a 5 volt signal. Uh guys. Parallel port digital outputs do not generally have a whole lot of drive. I really doubt a parallel port output could drive a relay. And it's probably TTL level equivalents, not CMOS. Even if you ganged the output bits together I doubt you would get enough drive out of them. A serial port output (+/-12 but you may see +/-10 or -5 and +12 or other out-of-spec combinations) is far more likely to be useful in driving a relay, though again there will not be much drive. It would be far better to supply the power you need from another source, like a +5V power supply. Or just get a wallwart with DC output and run it through a linear regulator. At least then you aren't likely to burn the house down :-) -Matt To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-hackers" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200210271919.g9RJJFEm091313>