Date: Wed, 20 Sep 2000 21:25:19 -0700 From: Rakesh Thakkar <rakesh@cell-works.com> To: freebsd-questions@freebsd.org Subject: Cable Modem Problem! Message-ID: <39C98DAF.B8C467E1@cell-works.com>
next in thread | raw e-mail | index | archive | help
Hello Everyone:
I am trying to connect my FreeBSD 3.4-Release to cable modem but I seem
to have a problem. My problem is that it work fine for about 7 minutes
after I boot my computer and then all the sudden the connection just
dies. I tried pinging freeBSD website and all the packets are lost. I
am attaching the /etc/rc.conf, dmesg and /etc/dhclient.conf files. I
think that I have followed the directions very carefully and I also have
looked on the website of FreeBSD to see if I can find any similar
problems but I couldn't find any. Thank you in advance.
This is the /etc/rc.conf file
# This file now contains just the overrides from /etc/defaults/rc.conf
# please make all changes to this file.
# -- sysinstall generated deltas -- #
linux_enable="YES"
moused_port="/dev/psm0"
moused_type="auto"
moused_enable="YES"
saver="daemon"
###############################################################
######### Important initial Boot-time options ##############
###############################################################
swapfile="NO" # Set to name of swapfile if aux swapfile
desired.
apm_enable="NO" # Set to YES if yo want APM enabled.
###############################################################
######## Network Configuration Sub-Section ##################
###############################################################
### -- Basic Network Options: ###
hostname="owml1.md.home.com"
nisdomainname="NO"
firewall_enable="NO"
firewall_type="UNKNOWN"
firewall_quiet="NO"
natd_enable="NO"
natd_interface="al0"
natd_flags=""
tcp_extensions="NO"
network_interfaces="lo0" # List of network interfaces (lo0 is
loopback)
network_interfaces="lo0 al0"
ifconfig_lo0="inet 127.0.0.1" # default loopback device configuration
ifconfig_al0="DHCP"
#### Network routing options: ####
defaultrouter="NO"
static_routes=""
gateway_enable="NO"
router_enable="YES"
router="routed"
router_flags="-q"
mrouted_enable="NO"
ipxgateway_enable="NO"
ipxrouted_enable="NO"
ipxrouted_flags=""
arpproxy_all=""
#### Miscellaneous administrative options ####
cron_enable="YES"
lpd_enable="YES"
lpd_flags=""
sendmail_enable="YES"
sendmail_flags="-bd -q30m"
inetd_enable="YES"
============================================================
This is the /etc/dhclient.conf
# $FreeBSD: src/etc/dhclient.conf,v 1.1.2.2 1999/08/29 14:18:41 peter
Exp $
#
# This file is required by the ISC DHCP client.
# See ``man 5 dhclient.conf'' for details.
#
# In most cases an empty file is suffient for most people as the
# defaults are usually fine.
#
interface "al0" {
send host-name "cc123456-a";
}
===========================================================
This is the dmesg
Copyright (c) 1992-1999 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights
reserved.
FreeBSD 3.4-RELEASE #1: Thu Aug 3 13:13:27 EDT 2000
rakesh@cc123456-a.owml.md.home.com:/usr/src/sys/compile/YOURKERNEL
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium II (265.54-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x634 Stepping = 4
Features=0x80fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,MMX>
real memory = 134217728 (131072K bytes)
config> di ze0
config> di lnc0
config> di le0
config> di ie0
config> di fe0
config> di ep0
config> di ed0
config> di cs0
config> di wt0
config> di mcd0
config> di matcdc0
config> q
avail memory = 127045632 (124068K bytes)
Preloaded elf kernel "kernel" at 0xc035c000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc035c09c.
Pentium Pro MTRR support enabled
Probing for devices on PCI bus 0:
chip0: <Intel 82443LX host to PCI bridge> rev 0x03 on pci0.0.0
chip1: <Intel 82443LX PCI-PCI bridge> rev 0x03 on pci0.1.0
chip2: <Intel 82371AB PCI to ISA bridge> rev 0x01 on pci0.7.0
ide_pci0: <Intel PIIX4 Bus-master IDE controller> rev 0x01 on pci0.7.1
chip3: <Intel 82371AB Power management controller> rev 0x01 on pci0.7.3
al0: <ADMtek AN985 10/100BaseTX> rev 0x11 int a irq 9 on pci0.15.0
al0: Ethernet address: ff:ff:ff:ff:ff:ff
al0: autoneg complete, link status good (half-duplex, 10Mbps)
vga0: <S3 ViRGE DX/GX graphics accelerator> rev 0x01 int a irq 11 on
pci0.16.0
Probing for devices on PCI bus 1:
Probing for PnP devices:
CSN 1 Vendor ID: ESS0968 [0x68097316] Serial 0x00000001 Comp ID: @@@0000
[0x00000000]
Probing for devices on the ISA bus:
sc0 on isa
sc0: VGA color <16 virtual consoles, flags=0x0>
atkbdc0 at 0x60-0x6f on motherboard
atkbd0 irq 1 on isa
psm0 irq 12 on isa
psm0: model Generic PS/2 mouse, device ID 0
sio0 at 0x3f8-0x3ff irq 4 flags 0x10 on isa
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1 not found at 0x2f8
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: FIFO enabled, 8 bytes threshold
fd0: 1.44MB 3.5in
wdc0 at 0x1f0-0x1f7 irq 14 on isa
wdc0: unit 0 (wd0): <Maxtor 85250D6>
wd0: 5009MB (10258920 sectors), 10856 cyls, 15 heads, 63 S/T, 512 B/S
wdc0: unit 1 (atapi): <MATSHITA CR-586/KS14>, removable, accel, dma,
iordis
acd0: drive speed 5515KB/sec, 256KB cache
acd0: supported read types: CD-R, CD-RW, CD-DA
acd0: Audio: play, 256 volume levels
acd0: Mechanism: ejectable tray
acd0: Medium: no/blank disc inside, unlocked
wdc1 not found at 0x170
scd0 not found at 0x230
ppc0 at 0x378 irq 7 flags 0x40 on isa
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
lpt0: <generic printer> on ppbus 0
lpt0: Interrupt-driven port
ppi0: <generic parallel i/o> on ppbus 0
plip0: <PLIP network interface> on ppbus 0
ex0 not found
zp0 not found at 0x300
adv0 not found at 0x330
bt0 not found at 0x134
aha0 not found at 0x134
aic0 not found
vga0 at 0x3b0-0x3df maddr 0xa0000 msize 131072 on isa
npx0 on motherboard
npx0: INT 16 interface
changing root device to wd0s2a
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?39C98DAF.B8C467E1>