Date: Sat, 24 Jun 2000 13:47:52 +0100 From: "Lawrence Farr" <lawrence@epcdirect.co.uk> To: <freebsd-smp@freebsd.org> Subject: Revisited: HP Vectra XU Message-ID: <NDBBJNMBOLGAIICJIEIGCEPICIAA.lawrence@epcdirect.co.uk>
next in thread | raw e-mail | index | archive | help
I posted this originally on the 7th June, and since then have had a bit of a play around with it. Upgrading to 4-STABLE a few days after this did not work, same error, but booting the same machine on the 4-CURRENT SMP kernel, it worked fine. Going back to 4-RELEASE again, I realised the machine was on Plug and Play. Turned it off, built a SMP kernel, and it was fine. Took it up to stable again, made world, made kernel, same result as below. I am assuming there is no hardware problem as it works OK on older code. Does anyone have any suggestions/patches I can try? -----Original Message----- From: Lawrence Farr [mailto:l.farr@epcdirect.co.uk] Sent: 07 June 2000 18:58 To: freebsd-smp@freebsd.org Subject: HP Vectra XU I have a HP Vectra XU, Dual PPro 200, 256Mb RAM, Internal Adaptec, that ran quite happily on a 4.0-CURRENT from mid January if I remember rightly. Upgraded to STABLE and it died on boot. Boots single processor OK, dual it wont. Blanked it, and put 4.0-RELEASE on there, same again. Single OK, Dual I get: (snip) avail memory = 257159168 (251132K bytes) Programming 16 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 Then stops. Any ideas anyone? Lawrence Farr EPC Direct Limited mailto:l.farr@epcdirect.co.uk T:01179666123 F:01179666111 M:07970780901 To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-smp" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?NDBBJNMBOLGAIICJIEIGCEPICIAA.lawrence>