Date: Mon, 24 Jun 2002 15:00:40 -0500 From: "Schroeder, Aaron" <Aaron.Schroeder@qg.com> To: 'ANTOINE Pierre' <nunux@free.fr>, alpha@FreeBSD.ORG Subject: RE: Digital StorageWorks 300AA & HSZ40C Message-ID: <025596A38A894B45AFE62346A6BF47464E25E9@waexch1.qgraph.com>
next in thread | raw e-mail | index | archive | help
I look at the console output again, and your cache battery may give you fits
as well. HSZ's are funny when it comes to cache batteries. If it still comes
up as failed, do a 'run frutil', hit yes to replace the cache battery, then,
when it prompts you to replace the battery, just hit enter, (hopefully) that
will clear any battery errors. Cross your fingers.
AJ
-----Original Message-----
From: ANTOINE Pierre [mailto:nunux@free.fr]
Sent: Monday, June 24, 2002 2:28 PM
To: alpha@FreeBSD.ORG
Subject: Digital StorageWorks 300AA & HSZ40C
Hi,
My Alpha 2100A perfectly boot with FreeBSD 4.6,
my problem (previous mail) was: "Put the VGA PCI card in first PCI block"!
I've surf a while before founding how to configure RAID on the mylex
controller, but it's finaly done.
Now, I'm seeking informations about a Digital StorageWorks 300AA
hooked to a PCI card: KZPSA SCSI Controller.
Is this StorageWorks Arrays supported on FreeBSD ? Has anyone an
StorageWorks
working with his alpha server ? Can you see disks in SRM or you needs
to access it via a special driver ?
On the server, I can see the SCSI interface KZPSA as pkb, doing show FRU,
and show CONFIG, but no disks.
I've hook a serial terminal to the Digital StorageWorks 300AA, playing at
9600 bauds and get a prompt. Any command fail and suggest to do a "SHOW
THIS_CONTROLLER" so i give you the result:
HSZ40C>SHOW THIS_CONTROLLER
Controller:
HSZ40 ZG61200481 Firmware V34Z-0, Hardware A02
Not configured for dual-redundancy
SCSI address 7
Time: NOT SET
Host port:
SCSI target(s) (0), Preferred target(s) (0)
TRANSFER_RATE_REQUESTED = 10MHZ
Cache:
32 megabyte write cache, version 2
Cache is INVALID. Cache containing unflushed data
has been removed from this controller
Battery is FAILED
Unknown unflushed data in cache
CACHE_FLUSH_TIMER = DEFAULT (10 seconds)
CACHE_POLICY = A
NOCACHE_UPS
Host Functionality Mode = A
This controller has an invalid cache module
Invalid cache -- CLI command set reduced. Type SHOW THIS_CONTROLLER.
Please-
see user guide to determine corrective action
HSZ40C>
Thanks for your tips.
----------------
ANTOINE Pierre
nunux@free.fr
---------------
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?025596A38A894B45AFE62346A6BF47464E25E9>